Ôªø 2003 Focus Workshop Manual
SECTION 501-14: Handles, Locks, Latches and Entry Systems
2003 Focus Workshop Manual
REMOVAL AND INSTALLATION

Ignition Lock Cylinder

Removal

  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the instrument panel lower panel.
    1. Remove the screws.
    1. Release the fastener.
  1. Detach the steering column upper shroud.
  1. Remove the audio control switch (if equipped).
    1. Using a thin bladed screwdriver, release the locking tang.
    1. Disconnect the electrical connector.
  1. Remove the steering column lower shroud.
    1. Release the steering column locking lever.
    1. Remove the screws.
  1. Remove the ignition lock cylinder.
    1. Insert and turn the ignition key to position I (Accessory).
    1. Using a thin bladed screwdriver, depress the detent.
    1. Remove the lock cylinder.

Installation

  1. To install, reverse the removal procedure.